michael8554

That plug doesn't look like it's factory fitted. So it would appear whoever installed it wired the plug on and just plugged it in.

Did the electrician unscrew and inspect the wiring of the wall switch at any time ? The terminal screws magically loosen over time. So...

If you want to generate power to reduce your electricity bills, solar PV is much simpler, reliable and cost effective.

Evacuated with the pump and left it with the pump off. Nothing lost after an hour, but pressure was halfway back to ambient the next...

Back in post #10 the OP said they still flickered with the timer is replaced by a switch ?

B32 MCB -> Socket -> Unfused RCD Plug -> flex -> 60 Amp MCB -> SWA -> CU -> B32 breaker -> ambitiously loaded ring circuit peaking at...

I see it's a bodge but can't see how it went wrong ?

My Fluke volt stick thoroughly confused me when my EVSE stopped working, showing volts all the way. There was in fact a poorly connected...

4 months on I can report that the unit has lost it's refrigerant ! Probably a connection not torqued correctly.......... ?? !! I decided...

Should be able to disassemble.

Are you sure you can't get into it? I always start from the premise that it's been put together, so how?

"Panel Heaters" are slim wall-mounted heaters, akin to a Storage Heater without the bricks to store heat. So only provide heat when...

Hi MooCow They're not very tolerant here of confused posts :-( "plug socket"- it's either a plug, or it's a socket, not both. Or as...

Bottom battery looks to be at 100%, the rest at about 66%. Switch off the lowest battery and switch on again when the rest are at 100%...

The premise is that the outdoor lights are powered from the B6 MCB, third to the right of the RCCB. Does that actually switch off those...