Hello Folks
I fitted the Danlers snubbers https://www.tlc-direct.co.uk/Products/DNCAPLOAD.html across the loads/lamps in both my two-way circuits according to clear instructions. Problem solved - these lamps no longer glow. However the nearby one-way in the bathroom still glows in the middle of...
@Special Location: So far, so good. Now if I buy this suppressor from Maplin, exactly what do I do with it? According to the first reply to my original post, Rob, do I just wire it in parallel across one of the two-way switches?
Thanks for all your help so far.
Regards
Bill
Hello Binky
Based on a little research I did last night, it turns out there are all sorts of snubbers for all sorts of circuits. I think what I'm looking for is some kind of RC circuit to run in parallel with a switch in a 240v 50hz 13a domestic house lighting application.
However I couldn't...
Hello Guys
Many thanks for your prompt replies.
@Blue Duck: Yep - I've had problems in the past with cheap imports from a very big country that shall remain nameless. Some that were advertised to last for 20,000 hours failed in less than 500 hours. Since them I've paid more for any I buy and...
Hello Folks
This is my first post so please be gentle.
Over the past year I have been replacing standard lamps and energy-savers with LEDs throughout our house.
This problem emerged when I installed 12W dimmable LEDs, all B22 bases, in the four ceiling lights on our first floor - two...