binky's latest activity

I have a relatively cheap one and it’s help narrow down 2 fault today at a park lodge site… one was water in a wiska box for some trace...

I would also check it is actually venting to the outside and not pumping damp air into your attic. Seen that far too many times.

Sound comments and I agree with all that. It's all about those raboo words Health and Safety at the end of the day. Wise words Trailer...

I'm not an Electrician. Turns out the bathroom fitter had Incorrectly wired at least one of the 21 wires coming through the ceiling...

Yep, I was aware its was on an approve and install basis, not the fit and notify basis of G98 for anything over 16A. Yep, aware it is...

It only takes a few quick tests to find out whether your MFT is affected by RCD / RCBO uplift and I have only seen 1 or 2 that do pick...

G99 is for export limited larger arrays. You need to make an application for such an array to the DNO prior to installation. So do that...

Interesting read. We could of course just use dead testing methods for the circuits.

If nothing else, this thread has shown massive inconsistencies. Those that say it is fine, when it is not, and those that say it needs...

Welcome to the forum.

Yep. As said above, if you have a normal light switch hanging around, you could try the lights without any timer, or even just use a bit...

Make a Rudolf 😀

It is always a good way to start. If you get really good global IR readings then no need to go further. But it it looks poor, then...

tarcked that down as a BG unit, data sheet says 40-400W tungsten filament lamps, so even if your LEDS are over 40W they may work, but I...

oddly enough this is correct, the actual requirement for insulation according to BS7671, is for 'the system' not individual circuits...