binky's latest activity

Talk Electrician Forum

Help Support Talk Electrician Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  • binky
    2 weeks is certainly excessive, which may indicate one knackered battery in the set. It might be worth disconnecting the entire set, and...
  • binky
    binky reacted to mort2376's post in the thread Help with specs! with Like Like.
    As people have said there are too many variables to be able to give a full definitive answer. With the distance involved and the...
  • binky
    binky reacted to nicebutdim's post in the thread Help with specs! with Like Like.
    Fair point • it was late and I didn't fully absorb that last post. I see mention of other services in the same duct - it might be...
  • binky
    binky replied to the thread Help with specs!.
    Trying to pull another cable through the same conduit will be far harder than replacing with the 10mm - use the existing cable to pull...
  • binky
    so it was working fine until you changed something - unchange it and see if works properly again. Equalize sounds like differences...
  • binky
    binky replied to the thread Major supply Upgrade.
    back feed is liited to 16A unless DNO says you can have higher, but you can install a larger solar array with 16A export limitation. If...
  • binky
    binky reacted to mindthegoat's post in the thread introduction with Like Like.
    Campsite owner responsible for general maintenance. Trained as an electronic engineer so can find my way around a circuit, hopefully...
  • binky
    binky replied to the thread Meter Maids.
    Or they just furked up. Probably didn't understand how to deal with the cable and buggered off. There's no excuse for leaving a property...
  • binky
    binky reacted to Nicky Tesla's post in the thread Meter Maids with Like Like.
    I’ve just got some from Rexel.
  • binky
    binky reacted to 7029 Dave's post in the thread Putting a new CU on a pre-pay metre with Like Like.
    PPM has no relevance to the installation. However for practical reasons make sure there is plenty of credit on the meter for your Live...
  • binky
    binky reacted to IzzyS's post in the thread Sheet metal punches with Like Like.
    I tighten QMax cutters with a hex adaptor in my impact driver. Does the job far quicker than the using an allen key and I haven't...
  • binky
    binky reacted to GeoffT's post in the thread Do you use an Abrafile? with Like Like.
    Used to use one, for timber mostly. Latterly have moved to a Dremel hand router with rotary cutter for odd jobs like cutting access...
  • binky
    binky replied to the thread Major supply Upgrade.
    they are a bit of a mystery :D You can get a third party to quote for the work, with DNO doing final connections I believe. That should...
  • binky
    binky replied to the thread Do you use an Abrafile?.
    not seen one of those for years, you could try diamond wire blade for a hacksaw, or one of these...
  • binky
    binky reacted to Thoth Amon's post in the thread Can anyone identify this connector? with Like Like.
    Thank you to @Geoff1946, @Marvo and @eckcop ! It does seem that there is no correct polarity and so I need not be concerned which pole...
Top