Not sure that an labc can stipulate that their own approved inspectors can only be used. If the inspector is approved to undertake 3rd party certification ( which involves close scrutiny of both knowledge and qualifications) then that should be sufficient. If you have had problems with refusal...
Hi.... try to find a local electrician who is a registered 3rd party certifier. He will be able to inspect and test the installation and certificate it. He will need the details of the original installer for certificate purposes and this will be accepted by labc.
Was it the builder that done the electrical works or did he bring in an electrician.... if he used an electrician then you could chase him for paperwork as it would have been his responsibility.
Hi fellas.
Hoping for a little help.... wiring in 2 separate uh3 wiring centres for 2 separate heating manifolds... plumber is using heatmiser system. Question is do i need to run separate circuits for each wiring centre or just run a radial circuit to incorporate both. Hope this makes sense...
I have done a few of these jobs where not wanting floor up to do recessed lights. As you say ceiling is being plastered i just cut a 6inch wide slot theough the centre of the room length ways across joists
..... this makes it easier for plasterer to repair, easier to drill joists and run cables...
I think you will find that a museum does not come under domestic works canoe boy. Maybe you should visit one and you might just gain an education.
I choose to do primarily domestic as it suits my needs. However my experience go's beyond that.
Hi Canoeboy, i am a one man band mate with a couple of builders who i work for. Also do voluntary work 1 morning most weeks for Tangmere Military Aviation Museum.
Currently doing 2 complet refurbs / rewires side by side with a third rewire to start on 5th August. Thats without a garage conversion and new garage to wire and another half a dozen smaller jobs waiting in the wings. Waiting on outcome of 2 other quotes for complete rewires possibly for october...
Ian932 i had a similar problem on a hdi expert. Mechanic saif duff turbo.... 700 later and problem still there. Turned out to be back box on exhaust blocked as when it blew off due to excess pressure full power was restored. Hth.
Ian932 i had a similar problem on a hdi expert. Mechanic saif...