truffle pig's latest activity

To be frank, if you've just bought a new house, spending around £1K is not even a drop in the ocean - so my advice to you IS upgrade the...

I can't quite figure out from your post if remedial work has been carried out to make the installation satisfactory for continued use...

So you spent many many £000's on buying a house including due dilligence and getting an eicr done, but have decided not so spend a few...

I think you would probably need 17mm heat shrink for the 2.5mm and 11.7mm for the 1.00mm

The incoming gas and water would need to be assessed to determine whether they would need bonding (less than 22k ohms to earth and they...

depends on the length of the cable - you would have to do a volt drop calculation to work out the capacity

If that terminal block is the original one that came with the fitting, and it is meant to slot into those two plastic lugs on the wall...

I must admit that I would sleeve a core at 2 way lighting etc, but have never sleeved control wires in a heating system 🤔

Are you certain about that? Table 51 does have grey as the colour for line 3 of a 3 phase AC circuit but surely that doesn't mean you...

If you are running Leds directly from smooth DC there will be no flickering

It's a wiring diagram showing how to wire the UFH wiring centre not the boiler - as you say, different boilers have different wiring...

as previously said, a personal recommendation is always best, if you can't find one try popping into a local dedicated electrical...

I always enjoyed fixing faulty central heating wiring. I was often called by my plumber mate to sort tings out. I am staggered by how...

I always hated doing earth rods as I was always paranoid about hitting a gas pipe, water pipe or anything else that wouldn’t act...

You also need to understand the results and whether they are within correct parameters.