Search results

so if i crimped the two cables together , this would be acceptable if buried in wall?

Thanks for the replys, it says in BRB 526.3 " appropriate compression tool" what is appropriate? who or what decides what is appropriate ? thanks again guys Any help appreciated

A socket is to be relocated higher up a wall and is fed from the bottom . Apart from replacing the whole length of cable , is it permitted to join the cable if it is to be buried in the wall? If not is it acceptable to use some form of connector if cable is run in conduit? Any suggestions/...

i didnt have any instructions with it

cheers ( yes it looks good lol )

May seem obvious, but what is the switched probe used for which came with megger MFT? Many thanks in advance

typical for this forum, cant give a straight answer, most would rather take the mick out of inexperienced thanks for all your help

what do you get?

what answewr do you get ?

Ive been doing a few mock exams foe my 2382 and am stuck on this one , not sure if the answer they give is right or not any help appreciated guys. A 30 amp semi enclosed BS3036 Fuse receiving a pfc of 130 A would disconnect in ? ill omit the answer they have so that i dont sway anyone , the...

Soon to gain 17th edition and C&G 2392 ( HOPEFULLY) is this enough to join competent person scheme to carry out Domestic electric work? Any help appreciated lads

what about the bonding to the water pipe? if i find the main supply is plastic? what would you suggest? ( all internal water pipes are copper) with a couple of plastic push fittings in the bathroom when rercent work was done

maybe i havnt got the correct terms, but i mean there is a 16mm earth from the supply and instead of connected to a MET its connected directly to the mains gas pipe

Hi guys, thanks in advance for any help I have recently taken up electrical course to hopefully become Domestic installer. since i started im forever looking round my house for faults/ problems etc I have TNCS SYSTEM there is no MET and the main earth is bonded directly to the gas pipe also...

Do i need to supplementary bond a bathroom radiator if it has copper pipes connected with plastic push fittings .I was thinking I may need to bridge the plastic Any suggestions and thanks in advance Rob