Search results

iCloud for me, not payed to upgrade but need to, photo stream takes lots of storage

did a 5 amp last week, blew quite a bit in the past, woman asked me to look at bedroom socket as it was blowing fuses when hairdryer was on, found that mr home owner had put himself a nice new socket, but into the 1.5 lighting circuit feeding extension lights. bleeding ring was only 6 inches away

how would you change the lamps when they blow?

hope weston power adopt this,all the seals fall off here in bath, would be nice to secure new ones proper :}

i never post out big or heavy goods, just state buyer collects and sell local.

yes hard to discribe. place off cut into corner then draw line top and bottom. then the other side top and bottom, take away off cut and you will see two lines top and bottom which meet in the corner, this gives you the marking points. hold new lenght up and mark top and bottom "left side" then...

i cut an off cut about a foot long then push into each side of corner and mark top and bottom, this will give you both points to mark on the cut. i use cove adhesive to bond it up. mark the bottom line and tack small nails to hold the cove in place, hold sections up before applying gloop to...

just past my first elecsa assessment GuinnessGuinnessGuinnessGuinnessGuinnessGuinness , phew! test rcd, ring final end to ends. Ze and pssc pefc. thanks to all the good knowledge from everyone.... cheer n beers applemac. http://www.talk.electricianforum.co.uk/images/smilies/Guiness.gif