Search results

Hello every one. I hope somebody can help me, so as I'm a bit confused about technical data received from client to provide new circuit for sunbed.  It is made in America and 3ph but 230 volts and I can't see Neutral incoming. Also some instruction from contractor guides: This unit requires...

I was in this house to move light fitting to the center of bedroom and discovered this.Also fan PVC ducting just lying on insulation, full of water and bring moisture to the loft.

Did him switch on brain?

Allow electricians to lawfully remove distributors fuses. http://epetitions.direct.gov.uk/petitions/37408

Found it in seller. Downstairs ring circuit ( 32 A MCB ), 15A terminal block has been used by builder. Couldn't leave it that.

Hello all. Need advise about cooker switch I have to change. Problem is wiring 16sqmm T&E and not so easy to connect, may be some of you used something different than ordinary cooker switch. Thank you.

No comment.

Hello everyone. Installed Low Profile Extractor Fan With Humidistat and when switch on power it started run straight ( switch for LS been switched off). Thought it needs time but after 1 hour steel was running. Disconnected permanent light, it stopped but no any reaction to switch when give...

Hello all. Has anybody installed more than 2 PIR sensors in series how advised in manual. Any problems with them? Thank you.

Hello. I'm just going to start install burglar alarm. Could you please explain in wish case I have to use EOL technology. I've got to connect 4 PIRs in series. Thank you.

Hello all. I've got a problem. Installed 20A radial for 3 double sockets. Main cable go up and then from Wago box 3 cables down to 3 sockets. 2 of them works fine but one shows voltage L-N 236V ( all right) L-PE 135V and N-PE 135V. Could somebody advise what can be wrong? Faulty socket I've...

Hello all! Has anyone used this type of RCBO? http://cpc.farnell.com/pro-elec/aub1r-32a/rcbo-single-pole-32a/dp/PL10658 Thank you

Hello all! Thank to everyone from this forum ,just passed assessment for ELECSA. Every your post was very helpful for me. Thank you again!

Hello all! I've changed CU today and when tested light circuit discovered that two switches(metallic) has not earth in.I know it is incorrect. Your advise please: What shall I write in EIC. I could not solve this problem(not visible joints available and I did it for assessment). I know that...

Hello all! Earthing conductor from MET to gas pipe 10smm 1,5 m long has right connection , after this connection it's going to water pipe and connected there (about 10m long). Is it correct or needs to be improved? Should it be two separated cables, or it is all right. Thanks!

Hello all! Have been changed CU for assessment. When tested ring circuit (s/o) it wasn't continuity at all. Somebody disconnected wire when been moving sockets. So I've left it as radial, it is 4smm cable with 1,5smm cpc,32A mcb,R1+R2 0,95, ZS 1,01. Everything looks OK. I've disconnected...

Hello every one! One question about new CU installation. Old one is about 2m under floor level and if install new CU same place it will not according BS. If change position on lower level needs make wiring longer or change all wiring. So how I could do it?Your opinions or advice... Owner's my...

Hello everyone! I glad to join your forum. I know how are you sceptical with electricians from EU.But most of the times you're right. I've finished technical school( college) in 1989 and worked as electrician for 16 years but I not work by this profession here because I understood I have to...