Search results

the stat turns off on lower setting if its left running long enough, tank is close to boiler all pipe insulated flow and return run hot

its unvented with one immersion, indirect. wilo bronzed pump , is what they recommend.because its potable would rather not have it on all day if a can be avoided, its just annoying that the stat does nothing, I guess the boiler stat will kick in as hot water keeps returning back.

space reasons fits in the eaves. apparently they don't work as well as the vertical ones

at bottem

not sure think they wiz the water up to stop legionella as some level of the tank  will be at the right temp. for me though its about getting the bottem of the tank hot as the coil only seems to heat the top, unless my stat is carp, its done it from new, its a dry pocket stat on an unvented system 

Hi all, I have a horizontal cylinder, the stat takes a long time to kick in, I spoke to telford who said a destrat pump would improve performance as the bottom of the tank does not heat up as well as the top. its never been a problem, as programmer brings it  on for 30 mins. but I would like the...

http://www.rselectricalsupplies.co.uk/gewiss-interlocked-switched-sockets-16a-2p-and-e-240v-gw66004_265 3 of these would prob be straight forward install, they can replace the fryers in future for anything up to 16a only concern I mentioned before was they could site the units under the...

two or 3 radials seems to be best option

will look at the sockets when I get them, see what there like and  run them on separate radials if need be thanks

runs 4m max will the terminal on these socket take 6mm in and out

32a -everything,  mcb, isolator, sockets and plugs, 4mm radial,

thanks the 32a sockets and plugs should be ok then

if I use the 32a sockets then it must be at least that

what is the issue I am missing here with them all on one circuit, these fryers are normally about 10A, so 3 on a 32A mcb, say 6mm or even 4mm to 32a isolator then feed x3 16A or 32A cee form sockets?

no one seems to be bothered in a work place, they just wreck the place

http://www.rselectricalsupplies.co.uk/gewiss-interlocked-switched-socket-32a-2p-and-e-240v-gw66015_268?gclid=COy3puDM5cYCFQoYwwodZzIKPw thanks like this one kme.  looked at these  before, they all seem to be expensive but just found this one which is quite reasonable. what do you think about...

its not a long run from the fryers could do a 20a for 2 ceeform and a 16a for the other

thought that might come up, was going down the fixed load route I could put in 3 fcu in the circuit but trying to avoid installing stuf that's could get damaged easily could do it over 2or 3 circuits,

I am thinking then 6mm to 32A  rotary isolator then 3x 2.5mm to 3 commando sockets,

just plugged into plastic  ip66  plastic socket at min, was called in to replace one as it had been smashed. all greased up, not nice work. noted that circuit and cable feeding sockets was overloaded, they said the mcb trips regular. will have a look at the flex and replace if necessary but I...