Search results

Building Regulations Document M

They have fitted two A3 standard circuitsv(Table 8A OSG) - I always prefer to install radials (A2) Just wired a church building using nothing but A2 and A3 circuits

Yes you can use the abode capture and paste into a graphic programme- or flash capture , etc

You are not allowed to use the exact ones (copywrite) - but you can make a variation

sorry this is the correct link http://www.theiet.org/publishing/wiring-regulations/DPC/index.cfm

you can view it here http://www.theiet.org/publishing/wir.../DPC/index.cfm

The New test Schedule -looks a lot better

Yes I stuck it in inspection and testing - to make sure it got picked up

Some changes to the wiring regulations- The PIR is on its way out - for the full document go to http://www.theiet.org/publishing/wiring-regulations/DPC/index.cfm

Sorry - this is the Link Page http://www.theiet.org/publishing/wiring-regulations/DPC/index.cfm

According to the Draft for public comment for the Amendment 1 of BS7671:22008 the PIr is on its way out and is being replaced by The Electrical Installation Condition Report - which contains a number of major changes to the classifications codes - But one of the better changes is the inclusion...

A metal gas or water pipe must not be used as an earth electrode. regulation 542.2.4 but an old water pipe could be used if precautions are taken against its removal reg 542.2.4

The name isond- Earth Bond

You can do an IR if the Dol has no electronics also you would have to disconnect the motor when doing IR otherwise you will pick up the motor windings- it is easy just to link the DOL out and do R1+R2 at the motor terminals back to Board. if you try and do it by mechanical operation of the...

Riggy are you suggesting He give the motor a handjob?

The name is Bond - Earth Bond

http://www.talk.electricianforum.co.uk/showthread.php?p=75647#post75647

Just in case anyone wants the solution - Strappers in on sw1 Common and sw2 Common - strappers out on sw1 -L1 andsw-1 L2 . links between sw1-L1 and sw2 -L2 ansd Sw1-L2 and sw2 L1 and both swirches operate in tandem

You can have a three way switching using only two-way switches - but the middle switch would have to be a two gang - with the switches glued together to operate in tandem- and wired with the appropiate links. (basically converting a two-gang 2-way into an intermediate)

Yes ideeed a snake oil guy - check out his rip off shop at http://www.russandrews.com/