Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Main Forums
Intruder, Fire, CCTV, Emg Light, Access Control
House Alarm Fault
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Talk Electrician Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Sharpend" data-source="post: 508341" data-attributes="member: 17152"><p>The fact that no power light is on would suggest an issue with power supply. Did you measure the mains voltage at spur or in the panel? </p><p> it sounds as though you have lost a fuse. There is more than one fuse iirc, so be wise to ensure power is off and check each fuse. </p><p> if battery is low, it may be that it has been on battery back up or the battery is dying and needs replacing. </p><p> 1) investigate and restore power supply.</p><p></p><p>2) see what lights come on. </p><p> 3) see if alarm can be reset. </p><p> 4) see if alarm sounds again.</p><p></p><p>5) with all accessories wired and terminated, check for continuity on tamper circuit. </p><p> 6) also check tamper to bell box as this is usually on its own tamper circuit. </p><p> </p><p></p><p>report back. </p></blockquote><p></p>
[QUOTE="Sharpend, post: 508341, member: 17152"] The fact that no power light is on would suggest an issue with power supply. Did you measure the mains voltage at spur or in the panel? it sounds as though you have lost a fuse. There is more than one fuse iirc, so be wise to ensure power is off and check each fuse. if battery is low, it may be that it has been on battery back up or the battery is dying and needs replacing. 1) investigate and restore power supply. 2) see what lights come on. 3) see if alarm can be reset. 4) see if alarm sounds again. 5) with all accessories wired and terminated, check for continuity on tamper circuit. 6) also check tamper to bell box as this is usually on its own tamper circuit. report back. [/QUOTE]
Insert quotes…
Verification
Post reply
Main Forums
Intruder, Fire, CCTV, Emg Light, Access Control
House Alarm Fault
Top