Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Main Forums
Do-It-Yourself (DIY) Question & Answer Forum
Myson Kickspace remote switch
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Talk Electrician Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Flash123" data-source="post: 495560" data-attributes="member: 32658"><p>Good Evening, I am attempting to fit a two gang crabree series 4000 remote switch supplied by Myson as well as cable to my existing Kickspace 500 Duo, heater which is at feet height, I have followed all instructions but it will not work. The instruction is to remove Yellow, Red, and brown wires from rocker switch mounted on the unit, and replace with supplied cable with like for like, so far so good. The switch end wiring which has two off, L1 L2 and L3 with the the L1's factory linked, it then shows the. brown wire (live) going to L2 top the red going to L2 bottom and Yellow going to L3,bottom but this does not work, could I have some help please , one question would be are these wiring arrangement correct and can it work with no connection going to the L1's</p></blockquote><p></p>
[QUOTE="Flash123, post: 495560, member: 32658"] Good Evening, I am attempting to fit a two gang crabree series 4000 remote switch supplied by Myson as well as cable to my existing Kickspace 500 Duo, heater which is at feet height, I have followed all instructions but it will not work. The instruction is to remove Yellow, Red, and brown wires from rocker switch mounted on the unit, and replace with supplied cable with like for like, so far so good. The switch end wiring which has two off, L1 L2 and L3 with the the L1's factory linked, it then shows the. brown wire (live) going to L2 top the red going to L2 bottom and Yellow going to L3,bottom but this does not work, could I have some help please , one question would be are these wiring arrangement correct and can it work with no connection going to the L1's [/QUOTE]
Insert quotes…
Verification
Post reply
Main Forums
Do-It-Yourself (DIY) Question & Answer Forum
Myson Kickspace remote switch
Top