Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Main Forums
Intruder, Fire, CCTV, Emg Light, Access Control
Newlec NL5704
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Talk Electrician Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="bassman" data-source="post: 76358" data-attributes="member: 1514"><p>Hi Mapleford</p><p></p><p>If the panel is showing both Zones in fault, I would sugest it is water ingress or earth fault as when you isolate the zones fault clears.Make sure cables are marked and take out of panel meter across both zones check for zone to zone readings.If you can read the end of line on one and not the other you will have to find the end of line shouldnt be to hard usually in a callpoint at the furthest point.</p><p></p><p>As the panel is showing clear when the zones are isolated you can assume that the panel is ok.Try the evac on the panel and make sure the sounders are operating.</p><p></p><p>Not sure of the panel but there are usually diagnostic LEDs on the mother board PC.</p><p></p><p>I will look it up and see if I can find any more info that helps.</p></blockquote><p></p>
[QUOTE="bassman, post: 76358, member: 1514"] Hi Mapleford If the panel is showing both Zones in fault, I would sugest it is water ingress or earth fault as when you isolate the zones fault clears.Make sure cables are marked and take out of panel meter across both zones check for zone to zone readings.If you can read the end of line on one and not the other you will have to find the end of line shouldnt be to hard usually in a callpoint at the furthest point. As the panel is showing clear when the zones are isolated you can assume that the panel is ok.Try the evac on the panel and make sure the sounders are operating. Not sure of the panel but there are usually diagnostic LEDs on the mother board PC. I will look it up and see if I can find any more info that helps. [/QUOTE]
Insert quotes…
Verification
Post reply
Main Forums
Intruder, Fire, CCTV, Emg Light, Access Control
Newlec NL5704
Top