Rossy

Thank you. The red and yellow cables attach to the STOP button on the rear of the cabinet door. One black cable from the coil was...

Hello Thank you for your helpful comments. Re: centrifugal switch I have checked the centrifugal switch and this appears to be...

Thank you I will investigate more in the morning (as it is now cold outside.....) Thank you for all your help

Thank you. I cannot see anything mechanically stopping it holding, other than the magnet not being pulled-up. When pulled up, it moves...

With dial turned to the 2K ohm setting, the measurement is 0.306 (up to 0.310)

The STOP button appears to be working okay. It appears to be 'Normally Closed' with continuity until this is broken by the pressing of...

Metex M-3800 digital multimeter, on the sound wave symbol setting.

Hello, thank you for your assistance. I have taken the magnetic coil (solenoid?) off the starter. Attached are some photos of it. The...

Thank you. Is the Coil as highlighted in the one photo attached? Yes I have a multimeter and should be able to check continuity with the...

Additional images attached

Hello, We have an old Alvan Blanch mill mixer machine used for processing and mixing grain for sheep and cattle feed. It is run by a...