Search results

Hi guys, Just after a bit of advice regarding the above if possible - I've recently been round to a customer's apartment as they explained their under-floor heating wasn't coming on anymore and they believed the heating controller, with it being old, was at fault. It did initially appear to be...

Hi guys, I'm just checking to see if anyone might have access to a Gardtec 300 series installation manual which you could email me? Just trying to make some amendments to a customer's part-set function and they only have the use manual which doesn't contain the information required. Thanks :)

I tested the IR before and it was fine. I'm back in the morning to investigate further. A borrowed neutral could be the answer. The occupant mentioned today that, from what they understand, the previous owner did some of the electrical work himself so that would add up.

Hey, Just after some advice on a CU problem I came across today I replaced an old rewireable fuseboard with a new dual RCD CU. The RCDs tripped when switched on. When working my way through each MCB to try and find the circuit(s) causing the problem it came to light that the RCDs were tripping...

I'm sure all will become clear upon inspection tomorrow. Just wanted to run it past you guys. Cheers.

I'm well aware that the neutral's been lost, what I was trying to establish was why this would have happened as nobody tends to be even on the that floor of the house.

Hi guys, Just wanted to pick your brains about something. Went to a call this evening where the customer said their bathroom lights (2 x large recessed downlights) has stopped working. Upon inspection I disovered that, when switching the lights on, 230v wasn't present between L-N. However 230v...

Thanks Manator. Just to confirm, only 2 wires are required - Is it bell+ to INH and bell- to IP1?

Hi there Manator, Here's the installation manual for the alarm if that helps? I don't have access to the alarm control panel itself at present as it's at a customer's property. PR4958 Rev21 Eurosec CP8 LED ENGINEER.pdf

Does anyone know which terminals to connect the speech dialler into on the Eurosec 816 alarm?

Here's the engineer manual for the wiring (Page 6) The 4 terminals where the wiring should be connected on the control panel aren't there Speech_Diallers_Alarm_Engineers_manual.pdf

Hey there, Just wondering if anyone might have a copy of the Eurosec GTA 816 installation manual? Just trying to install a speech dialler but not sure where to wire it into on the control panel as the instructions which come with the speech dialler don't tally up with the terminals on the...

Thanks very much for that Badger, I really appreciate it :)

Hey guys, Just wondering if anyone has an installation manual for this burglar alarm? Thanks

Just sent it Galaxy. Cheers

Hey guys, Just wondering if any of you might have this burglar alarm installation manual to hand? Thanks

Hey guys, I know there's been a recent thread regarding light bulbs blowing continuously but a job I've been on today took this a step further. The customer needed some unrelated electrical jobs doing but whilst there he told me he's had a relatively long standing problem of bulbs blowing...

It was a lot longer than that, it was well over an hour. It's an old alarm though so that might be why. Cheers

Why does the external sounder continue to sound when the mains power and battery have been disconnected? Disconnected a Bentley F133 burglar alarm today, on request, and the external siren went off and continued for ages. Do they have a built-in battery back-up? Cheers

So from L2 at switch to L1 at light i.e. no connection in L2 at light? ---------- Post Auto-Merged at 17:28 ---------- Previous post was made at 17:26 ---------- I tried that. Power to L2 is going off. Power to L1 remains continuous with it being a permanent live.