Search results

can someone help me with this.  I'm not sure how the zone should be set.  I've copied and paste from the manual, do i select 0 or 1? 21: Zone Configuration This command enables you to select the wiring type of the zone connector on the control unit PCB. The default is option 0 for all models...

yes, that what i did before replacing the cable. 

thanks for the advise

hi I've linked them thru and that resolves that problem. Now i have a different issue, because i loaded the default settings i need to program the system for the zones and part zone.   I when i set the system as it is it won't set

theres nothing in zone 7 or zone 8

hi again, Ive removed the bell box bought it inside near the control unit.  I've installed a temp cable and this has removed the previous fault but now it comes up with 'Zone FLT Z08'. I've looked in the manual and i can't find out what it means.  Keeping in mind i have loaded default setting...

ok, thanks for all your help.  I'll report later with an update. Thanks Again

I've just realised I'm in the middle of decorating and had someone cut the carpets so i could paint the skirting boards.  I can see the tamper bell cable where the carpet has been removed but I've checked it and it doesn't seem to be damaged.  Should I replace the cable first before changing the...

thanks for the quick reply, Ive looked at the manual and have gone into installer mode, loaded defaults and exit installer mode.  it did a system check and then comes up with 'Bell Tamper'.

Hi, For the past few days I've had an error come up on my keypad with the spanner light on.  when i enter my code in to set the alarm it doesn't set but says 'RESET required sounder tamper'.  Its a Scantronic 9651 system.  Ive had someone out and he has tries the master code but it won't reset...

Thanks jl-heating for the info

Thanks Sparky, I'm not too comfortable with the boiler position either but your suggestion of a cupboard for the consumer unit/meter is very helpful.

Hi, this is my first post & would appreciate some help. I'm a gas safe engineer and need some help with some electric regs. Customer has asked to install a boiler in a under the stairs and I've checked all measurements but the problem i've got is there is a electric meter and consumer unit...