Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Main Forums
Do-It-Yourself (DIY) Question & Answer Forum
Converting 3 phase car ramp to single phase
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Talk Electrician Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Neepcutter" data-source="post: 520735" data-attributes="member: 34314"><p>Hi All</p><p></p><p>I am new on here and looking for some advice on converting a car ramp to single phase. This particular ramp is sold in 2 versions single or 3 phase. I bought a 2nd hand 3 phase version at very handy money so can justify a bit of spend on it.</p><p></p><p>The 3 phase version i have has a 2.6KW 4 pole motor driving a 4.8cm3/g pump</p><p></p><p>The factory single phase version would have had a 2.2KW 2 pole motor driving a 2.0cm3/g pump</p><p></p><p>So question is ,worth a shot at buying a cheap 7.5KW VFD of Amazon and wire it in 240v delta config or swop it over to a 3.0KW 2 pole Cap start single phase motor B14 not sure what route would provide the most start up torque especially when the ramp is loaded</p><p></p><p>Any advice would be most appreciated</p></blockquote><p></p>
[QUOTE="Neepcutter, post: 520735, member: 34314"] Hi All I am new on here and looking for some advice on converting a car ramp to single phase. This particular ramp is sold in 2 versions single or 3 phase. I bought a 2nd hand 3 phase version at very handy money so can justify a bit of spend on it. The 3 phase version i have has a 2.6KW 4 pole motor driving a 4.8cm3/g pump The factory single phase version would have had a 2.2KW 2 pole motor driving a 2.0cm3/g pump So question is ,worth a shot at buying a cheap 7.5KW VFD of Amazon and wire it in 240v delta config or swop it over to a 3.0KW 2 pole Cap start single phase motor B14 not sure what route would provide the most start up torque especially when the ramp is loaded Any advice would be most appreciated [/QUOTE]
Insert quotes…
Verification
Post reply
Main Forums
Do-It-Yourself (DIY) Question & Answer Forum
Converting 3 phase car ramp to single phase
Top