user 15807
Junior Member
- Joined
- Nov 22, 2011
- Messages
- 45
- Reaction score
- 0
Hi All,
I have done some work on a system with the following Ademco RKP, I understand that honeywell Bought out Ademco and see there are honeywell branded RKP's that look the same. Is it possible this is a Honeywell G2 panel? there is no identifying marks in the endstation, other than perhaps firmware version number on a chip.
Please see the picture of the panel attached, the image is from ebay but identical except i have a sticker on the square chip above zones 2,3 and 4 which looks like a firmware version number, but i havent seen a G2 with the keypad which is the actual one taken this morning.
I have found loads of videos and instructions for ademco alarms saying to power up panel, press * and # then *20 enter new code and *99 to leave engineers menu, its not having any of that!
Anyone who can identify this setup and point me to a manual or method, I would be really grateful. Panel is dated install of 2005
I have done some work on a system with the following Ademco RKP, I understand that honeywell Bought out Ademco and see there are honeywell branded RKP's that look the same. Is it possible this is a Honeywell G2 panel? there is no identifying marks in the endstation, other than perhaps firmware version number on a chip.
Please see the picture of the panel attached, the image is from ebay but identical except i have a sticker on the square chip above zones 2,3 and 4 which looks like a firmware version number, but i havent seen a G2 with the keypad which is the actual one taken this morning.
I have found loads of videos and instructions for ademco alarms saying to power up panel, press * and # then *20 enter new code and *99 to leave engineers menu, its not having any of that!
Anyone who can identify this setup and point me to a manual or method, I would be really grateful. Panel is dated install of 2005
