More machinery...

[netblindpaul]

"2712" is an estop control system contact operating at 400V a.c. the interior of the box as found.

"2714" is an idea of a safe joint again on a 400V a.c. control system.

"2715" is someones idea of the safe method of entering cables into an enclosure again 400V a.c. control, in an environment subject to 7617 BE2, and bordering on DSEAR zone 22!

Most of the pictures I have posted have these constraints, that is BE2/DSEAR zone 22, which is why they were taken / posted.

"2716" strain relief?

"008a" IP65 rated control panel, NOT, modified by forklift!

 

[revjames]

Great Paul..... wheres the pics? done some work and training on ATEX/DSEAR so would be interested to see.

 

[netblindpaul]

Rev,

Files did not upload, have edited post!

 

[revjames]

First looks like a telemecanique

second is cutler hammer (later became eaton)

the knotted cable isquite a common method!

amazing what some people live with on a daily basis and think its OK

 

[netblindpaul]

1st is MEM I think IIRC

2nd, no blinkin idea! Well old tho'

Knotted... Hmmmm

 

[revjames]

1st one does look like telemeq but 2nd one is CH and would put money on it. actually not that old just very robust and over engineered. They were still stores stock when I was there up til last oct.

I sound like a nerd.........

 

[netblindpaul]

Rev,

1st is not Tele, it is rear mounted and front actuated in a cast Al box.

Tele ZB2 & ZB4 were front mounted and front actuated.

Only the new pb's are back mounted.

The box is grey cast AL, button is also but red. No yellow surround to comply with PUWER etc.

I may have a pic, if I do I'll post it.

 

[revjames]

Quite right about the 1st one. as you say ZB2/4 front mounted.

You are as bad as me!

 

[netblindpaul]

Yep!