Hi guys
installing a new hob and oven for my dad tomorrow, exisitng one is outdated to say the least.
Induction hob is 6200W and oven is 2500W.
so calculated 38A for both.
Existing cable is 6mm, so think that is fine.
current set up a bit of a mess!
So from cooker switch I am going to run 6mm to a cooker connection unit for the hob.
For the oven I am going to install a fused connection unit (13 amp) and run 2.5 from it to the oven.
My question is would you spur off the cooker switch or the ccu for the fcu to feed the oven and would you feed the fcu in 2.5mm or 6mm?
Is this acceptable the way I am planning on doing it?
I currently only work commercial so have very ltd domestic experience.
Thanks Guys
Craig
installing a new hob and oven for my dad tomorrow, exisitng one is outdated to say the least.
Induction hob is 6200W and oven is 2500W.
so calculated 38A for both.
Existing cable is 6mm, so think that is fine.
current set up a bit of a mess!
So from cooker switch I am going to run 6mm to a cooker connection unit for the hob.
For the oven I am going to install a fused connection unit (13 amp) and run 2.5 from it to the oven.
My question is would you spur off the cooker switch or the ccu for the fcu to feed the oven and would you feed the fcu in 2.5mm or 6mm?
Is this acceptable the way I am planning on doing it?
I currently only work commercial so have very ltd domestic experience.
Thanks Guys
Craig