danny7299
Well-known member
I have been wiring up a little shop and they have put in a plastic water feed.
I ran a 10mm bonding to it, just to be sure, but wanted to check with you lot.
Not sure if they are going to continue the whole installation in plastic or not.
I know common sense says if the whole thing is plastic no need to bond, but if the plumb in copper from the plastic main then bonding would be needed?
Can some one shed some light?
Thanks
I ran a 10mm bonding to it, just to be sure, but wanted to check with you lot.
Not sure if they are going to continue the whole installation in plastic or not.
I know common sense says if the whole thing is plastic no need to bond, but if the plumb in copper from the plastic main then bonding would be needed?
Can some one shed some light?
Thanks