4 gang double pole swich? do they exist?

[NozSpark]

I think that the switch modules in GET switches are removable.. so you could possibly get a 4 gang light switch and replace all the switches with DP switches??Looks a bit neater than grid

SorryBlushingBlushingBlushingBlushingit's not GET,,, it's Click!!

 

[jibspark]

it was a grid but wasnt the problem. the problem turned out to be a tranny for a couple of elv lights.

 

[Andy™]

it was a grid but wasnt the problem. the problem turned out to be a tranny for a couple of elv lights.

i dont think them spare grid switches would have been much use for that!

 

[jibspark]

i dont think them spare grid switches would have been much use for that!

very true! for the same job i had to find a problem with some lights in the kitchen, thought it is bound to be a tranny so bought one on my way there, turned ot to be a dimmer! live n learn!

 

[Andy™]

youll soon find out what materials your going to use often and can keep a stock of them in the van

 

[jibspark]

youll soon find out what materials your going to use often and can keep a stock of them in the van

yea im slowley buying a bit of stock to keep in the nav. just not the right stuff!! lol

 

[Andy™]

if you need something, buy 2

 

[jibspark]

good advice! cheers andy!

 

[green-hornet]

A word of caution if you are going to wire multiple circuits into a single control box, as is listed here.

Make sure its well lablelled.

I have seen so many people isolate one circuit only to find other circuits present in one enclosure.

 

[jibspark]

A word of caution if you are going to wire multiple circuits into a single control box, as is listed here.Make sure its well lablelled.

I have seen so many people isolate one circuit only to find other circuits present in one enclosure.

it appeared all 4 switches were on the same circuit. they were just switching socket outlets for particular appliances where the sockets were almost inaccessible.

 

[Andy™]

A word of caution if you are going to wire multiple circuits into a single control box, as is listed here.Make sure its well lablelled.

I have seen so many people isolate one circuit only to find other circuits present in one enclosure.

do you label the light switch on the stairs if you have 2 circuits in there?

 

[NozSpark]

do you label the light switch on the stairs if you have 2 circuits in there?

There are quite a few people who think you have to do this, but all the regs ask for is a single point of isolation for circuits which share an enclosure... That'd be the main isolator then!!!

Of course if it's 3 phase then I'd put a 400v sticker on it!!