Not mine!
Mine was a LOT smaller than that.
To big for me to handle and as it turns out too small for them to handle.
Bearings £2k, customer supplied, fitted to the spindle by me today.
Spindle front flange circa £500 smashed up by supplier.
Spindle itself damaged by supplier, cost £500 ish.
Locking nut damaged by supplier cost £100 ish.
So, around £1100 of damage for a simple job that was just too big to fit in my press.
So, perhaps, I should say ex-supplier!
Replacement unit rebuilt and in the back of the van for refitting tomorrow into my customers machine.
Taking a winger as I don't have all the info on the pre-load on the bearings.