Search results

Yep MWC not suitable for change of cu

If you refer to the whole of the HSE documents then you will see that HSE at this stage were entering into the consultation procedure for the possible replacement of CORGI, and in certain documents it states that CORGI may be replaced and any references to CORGI are taken to mean CORGI or it...

Discuss the limitations of the inspection with the customer. A PIR does NOT require 100% testing of circuits, IIRC GN3 suggests a 10% sample for dismantling & testing. I don't believe it would be undreasonable to leave some circuits untested due to not being able to isolate etc. Quite...

Quote from: Statutory Instrument 1998 No. 2451 The Gas Safety (Installation and Use) Regulations 1998 PART B GAS FITTINGS - GENERAL PROVISIONS Qualification and supervision 3. - (1) No person shall carry out any work in relation to a gas fitting or gas storage vessel unless he is...

DREAM for me too! I have a full unrestrited licence, so I could (IF I had the money) go out and buy an unrestricted bike tomorrow and ride it to my hearts content. MIND, I've not thrown my leg over a m/cycle saddle for 10 years! I would love to get back to it... I would probably go for...

That's actually what I have done, but they seem to have other ideas!

Hi, I've put a price together for a commercial rewire following a fire incident. One section of the building completely gutted, it has affected the wiring in the other w/shop, the complete upstairs lighting in the offices, db's damaged etc. etc. 2 workshops, 2 stores areas, 3 toilets, canteen...

Please remember if you are going to design the extraction system then under legislation you must be competent to do so. If you are only installing the supplies and someone else is designing and providing the system then fine, else beware! This sort of system is classed as Local Exhaust...

IIRC it is illegal to sell an electrical appliance into the UK market without a BS plug fitted. Thus the supplier has commited a criminal offence under statutory legislation. Edit. Remember a "shaver" plug is a BS plug!

DAMN, yooz lot have been busy! I pop out to get some passport photos for my JIB card and there's a ton of replies when I get back! :|

Had bad experiences with NatWest, RBS & Barclays! I have a few business contacts who have had issues with HSBC. Looking to move to LoydsTSB as I have a few business contacts who are with them and they seem to be sound!

I can get most things sharpened for you by my guys including hole saws!...

Customer has been advised in writing of the issues including these pictures. They have also been sent to the customers H&S dept. I have treaceability on the communications. They have to date not responded to request repairs.

2659 & 2664, customer allowed us to clean out the panel and block the hole, but would not allow the replacement of the fuse holder and damaged wiring. 0529, this type of gland has ridges on the inside of the clamping faces, these can easily cut into the singles through vibration etc...

[quote name='Andy

Yep!

Rev, 1st is not Tele, it is rear mounted and front actuated in a cast Al box. Tele ZB2 & ZB4 were front mounted and front actuated. Only the new pb's are back mounted. The box is grey cast AL, button is also but red. No yellow surround to comply with PUWER etc. I may have a pic, if I...

Look guys, sorry to be the party pooper, however, none of you are legally allowed to pull the DNO fuse unless you are a DNO employee or other person authorised by the DNO in writing. If you do and something goes wrong you are in breach of EAWR89, and possibly ESQCR. I'm sure the DNO guys on...

1st is MEM I think IIRC 2nd, no blinkin idea! Well old tho' Knotted... Hmmmm

Ha Ha!