Search results

bond on the copper at the stop cock and from there on the copper just after that poly pipe, one unbroken cable run ---------- Post Auto-Merged at 21:42 ---------- Previous post was made at 21:40 ---------- answered befor you asked:)

why would you not bond, metalic incoming service or have i missed something? ---------- Post Auto-Merged at 21:38 ---------- Previous post was made at 21:36 ---------- looks like it has previously been bonded, whats that g/y on the right?

nice one mate traded osg and brb.

are you compleating certs on line or hand written? you could ring napit tec line and get them to comfirm what is required for the work you do, however as mentioned if management preference that a cert is to be issued then issue one. dont know the ins and outs but if your being paid to do some...

+1 like for like swap

select one from here top most beautiful women - Google Search or here top most beautiful men - Google Search post your selection, or pm me if you would rather keep your choice confidential ;) and i will have him stroke her sent right out

well how els would you know its fragile

if all testing is done at L+N to earth then in the scedual of item tested, i tick the box insulation resistance between live conductors and earth and put N/A in insulation resistance between live conductors. in test results I just put L+N - E >299 ect

what were your trip times at X1 and X5 what is the rcd bs number but any how as andy says if you did not test the rcd in isolation then your results may be inaccurate

try testing at the cu with all breakers off

found something similar but fused down and taken from the outgoing L of the rcd

have done this once when lug was compleatly knacked, so much you could push the screw through the hole, anyway may be a bit rough but, with some fast setting strong glue (mitre mate) i stuck a small pice of plastic behined the lug then drilled and taped it.

bloody ell, some people are numb. i had one dodgy diy this week ring split over 2 fuses one of which doubled up with cooker circuit

when i started out i made a Pledge to do a good job

done and dusted now, the circuit is 6 single sockets around the house, none in the kitchen

so best thing to do is keep it on the 20 Amp, put the end to end on the cert, and a note in the comments about mutiple spurs from single point

thats end to end at the board, R1+R2 ranges from 0.3 to 0.8

there are end to end readings 0.10 for the live conductors and 0.26 for the 1mm cpc, small ring mutilple spurs

this is similar mate except all from one point, will definatly keep it on the 20A, on the cert should i not bother with the end to end readings then

hello, changed a cu in a house and one of the ring final is set up as, ring too an enclosure then mutilpe spurs from this point to sockets this set up is a bodge and i think the best thing to do is treat it as radial and use a 20A mcb which will be adequate for the load. just want to see what...