GrahamAHitchcock
New member
Hi I'm working on a roller door that is probably 25 years old and with no wiring diagram.
Anyone know where this would be available on here please???
Anyone know where this would be available on here please???
you did. and after a very quick search, i found it hereI posted a Garog drawing on here in the distant past , I think, try doing a search of the Forum . I remember Sidey warning me about copyright .
Not me I think!I posted a Garog drawing on here in the distant past , I think, try doing a search of the Forum . I remember Sidey warning me about copyright .
been there before... done one a while back, had to get the largest ladders into the room i could fit through the door / corridors, which only went half way up the wall. then had to use a stick with a DIY hook on the end to try and lift the chain from its perch onto the end of the motor, so i could get the shutter up enough to get the bigger ladders so i could get at the controlsSomething like 1000 ft of chain pulled = 1 inch of door movement.
Enter your email address to join: