I have just acquired a house with a Warmflow Bluebird Oil boiler - probably installed in 2004.
There is no programmer attached to the system at all. It seems almost too simple. The only " controls" are :
Programmer and Room Thermostat ) and would be grateful for any advice
re the following questions :
Graham
There is no programmer attached to the system at all. It seems almost too simple. The only " controls" are :
- An ordinary electrical on/off switch ( Marked " Boiler" in felt tip ) wired to the thermostat hanging on the front of the boiler.
- An ordinary electrical on/of switch wired to what is the
circulating pump( so far as I can see there is only one pump but the
house is a bit of a rabbit warren so there may be another one somewhere).
Programmer and Room Thermostat ) and would be grateful for any advice
re the following questions :
- Is the Salus T 500F the right sort of kit to do what I want, which
is basically to programme on/off phases and set a max temperature/ - If so, am I right in thinking that the Salus should be connected to the wiring that currently goes to the "Boiler" switch?
- Should the pump be connected in some way to the Salus?
- If not, do I need to install some separate controller for the
pump, or should I just leave that with the switch permananetly in the
off position/?
Graham