Stripping Outer Sheath Flat T&e

[Zeespark]

Rob - not needed, with the cable holding the sleeving in one end, and the accessory the other, whats the point?

Andy Guinness

 

[Jono Pashley]

Rob - not needed, with the cable holding the sleeving in one end, and the accessory the other, whats the point?

Andy Guinness

About as much point as p****** around evening up the cable sheath

 

[steptoe]

About as much point as p****** around evening up the cable sheath

:Applaud    :Salute

and that, sir, is that,

 

[OnOff]

About as much point as p****** around evening up the cable sheath

I know! There's some proper weirdos about........

:innocent

 

[kerching]

I know who is going to be knocking at your door!

 

[kerching]

My H07 Heatshrink Joints with 7 or 12 core look similar to that, ill do a piccy in a few weeks time when I'm next ding some, only downside is the cable lay is different both ways so its not 100% neat

Well, we strive for perfection so i suppose 99% is acceptable

 

[OnOff]

My H07 Heatshrink Joints with 7 or 12 core look similar to that, ill do a piccy in a few weeks time when I'm next ding some, only downside is the cable lay is different both ways so its not 100% neat

Posted before in a "crimping" thread but you can't beat neat IMHO:







I've extended T&E before & soldered rather than crimped the staggered joints. Then atop the heatshrinking sleeved the whole lot with a bit of sheath from the next size T&E up..........and then heatshrunk over that. That comes out very neat.